24 thoughts on “Program PICAXE with Arduino! How-To

  1. why doesn’t this …
    why doesn’t this work for me i’ve been trying? for days now. i plug in the arduino upload the program to blank it out. then i go to switch over to the picaxe programmer and it says “com port already in use” WTF? its driving me insane.

  2. Hey dude, im …
    Hey dude, im following ur vids, theyr awesome
    The Uno uses the Atmega8U2 programmed as a USB-to-serial converter so? will i still be able to program a Pic?

  3. @Flea5000000000 yes …
    @Flea5000000000 yes because the signals are inverted, well at least if you use the FT232RL converter from FTDI. ? There is a workaround though, if you download a free utility called FT_PROG from FTDI, you can actually reprogram the converter to invert the signals

  4. Can I use a USB to …
    Can I use a USB to Serial converter? If? I can do that, do I have to use this circuit????

  5. I can’t get this to …
    I can’t get this to work I’m getting a ” Memory verification failed – byte 255″. I believe I have everything connected correctly, the only difference is I’m using an UNO. I’m using the Arduinos pwr supply and have tried? using 4.5 volts, but no go. Thanks in advance.

  6. @herctrap when I …
    @herctrap when I ran that test tool, the logic was opposite from what? it was supposed to be. I looked into it a little, and it turns out they use a form of RS232, which is why you need to use resistors with their cable

Leave a Reply