How to make a robot gripper

To make this project you will need:
A small blow torch or lighter
A glue gun
A Dremel or rotary tool
A few rotary tool bits(drill, sanding wheels and a cutting wheel)
A permanent marker
The Cutting pattern(can be found here http://kattejuice.deviantart.com/gallery/27672731#/d32rir4 )

A micro servo
4 small nails or pins
A piece of Plexiglas (acryllic, 2×2 inches or 10x10cm)
A large paperclip
And some sealing tape

If you dont have a rotary tool use a drill, some sanding paper and a fine saw.

This project is very cheap! only costs about $10!!
-A micro servo -$5 to $10 (mine was $6!)
-4 small nails or pins -FREE
-A piece of Plexiglas -$1
-A large paperclip -FREE
-Some sealing tape -$1

This project is not for beginners, if you are new to robotics please go see this: http://www.youtube.com/watch?v=hMXTs-33xbs
or this: http://www.youtube.com/watch?v=D1speabcZNA
or this: http://www.youtube.com/watch?v=2wJ8EMu7gOM
and dont forget this: http://www.youtube.com/watch?v=VAATI2VOjlU

Duration : 0:9:57


[youtube D9R20FSdQ_Q]

15 thoughts on “How to make a robot gripper

Leave a Reply