Category: Battlebot
Antweight Battlebot chassis
The is the spinning chassis of an antweight (1lb or less) battlebot that I designed using Solidworks. The outer spinning portion and the top and bottom of the chassis were water-jetted from 6061-T6 aluminum pieces. I used a lathe to turn down a 1/4″ steel shaft to the correct length and add grooves for snap…
BattleBots – Part 1
AutodeskMFGhttp://gdata.youtube.com/feeds/api/users/autodeskmfgTechBattlebotBattleBots – Part 1 Duration : 0:10:5
For an antweight battlebot, I’m wondering about the speed controller?
I’m planning on using a brushless motor for the weapon, and possibly two brushed motors for the wheels, so do I need more than one speed controller? Do I need a speed controller for brushed motors? Can one speed controller be used for multiple motors? If you have any recommendations in general that would be…
Dethinator vs. TGTB – battlebots/botsIQ 2009
Dethinator from Pine View HS vs. TGTB from Carrollton. botsIQ/battlebots 2009 in san francisco Duration : 0:2:23
Lego Battle Bots, Commander Wedgie vs. Zone
Battle of the Wedges! I made a semi arena because the other one is to small, i could not find i nice sheet for the floor of it. Duration : 0:1:34